SEAFLO 12V 600GPH 13A Non-Automatic Submersible Bilge Pump
BP1G60013A
- Dispatched in 2-3 days
- 30 Day Return Policy
- In stock, ready to ship
- Backordered, shipping soon
Compact 12V drainage for small boat compartments
The SEAFLO 13A Series 600 GPH pump is a compact 12V DC non-automatic submersible bilge pump for small craft, tenders, RIBs, yachts and fishing boats. It provides straightforward bilge-water evacuation where a separate control method is preferred.
There is no built-in water-level or timer sensor. Connect it through a correctly rated manual switch, float switch or bilge control panel.
Design and service features
- Quick-connect cartridge lets the motor module be removed while the base and plumbing remain installed.
- Threaded removable discharge adapter provides straight or configured hose connection options.
- Integrated check valve helps reduce water returning from the discharge line.
- Fully submersible and ignition protected for marine bilge installation.
- Stainless-steel shaft, moisture-tight seals, tinned blocked marine wiring and anti-airlock design.
- High-efficiency, low-current motor with quiet operation.
- Designed to meet CE, RoHS, ISO 8846 and ISO 8849 requirements.
Technical specification
| Manufacturer model | SFBP1-G600-13A |
| Replacement motor model | SFMA1-G600-13A |
| Operating mode | Non-automatic; external control required |
| Supply voltage | 12V DC |
| Open-flow capacity | 600 GPH (approximately 2270 L/h) |
| Rated current | 2.5 A |
| Maximum head | 2.5 m (7.5 ft) |
| Outlet range for series | 19 mm (3/4 in) and 29 mm (1-1/8 in), depending on supplied adapter |
| Approximate size | 122.7 × 76 × 120 mm |
| Approximate unit weight | 0.47 kg |
Boat compatibility and installation checks
- For 12V DC marine systems only; do not connect directly to a different nominal voltage.
- 600 GPH is an open-flow rating. Installed output falls with vertical lift, hose length, bore, bends, fittings and restrictions.
- Use reinforced smooth-bore hose matched to the selected 19/29 mm outlet, keep the run short and rising, and provide anti-siphon protection where required.
- Size the fuse, switching device and marine-grade cable for up to the pump circuit's rated demand, allowing for cable length and voltage drop.
- Mount the strainer at the lowest practical point, keep it accessible for cleaning and test the complete system regularly.
- Use only for bilge water. It is not suitable for fuel, oil, sewage, drinking water or abrasive liquids.
- Package: one 13A Series pump with supplied base/check-valve discharge parts. External switch, hose, fuse and main wiring are installation items.
Frequently asked questions
Is this an automatic pump?
No. Add a suitable float switch or controller if automatic operation is required.
Can it be wired directly to a battery?
It must be installed with suitable circuit protection, cable and switching. Follow marine electrical practice rather than using an unprotected direct connection.
Can the cartridge be changed separately?
The split quick-connect design allows the motor cartridge to separate from the installed base; match the replacement motor exactly.
Is it suitable as the only bilge pump on my boat?
That depends on vessel size, compartment risk and required installed capacity. Check the boat builder's and applicable safety requirements.
For the products under £150 the shipping is £6.99.
Free delivery for most items over £150.
