AMC 25mm² Red Flexible Battery Starter Cable 10m PVC25.10.R
PVC25.10.R
- Dispatched in 2-3 days
- 30 Day Return Policy
- Low stock - 1 item left
- Backordered, shipping soon
AMC 25mm² Flexible Battery Cable
Red PVC Sheath | 10 Metre Reel | SKU PVC25.10.R
AMC flexible 25 mm² battery cable supplied as a continuous 10 metre red reel. The fine-stranded construction supports neat routing in battery, starter and DC distribution circuits where 25 mm² is confirmed by design calculations.
Key Features
- Fine-stranded flexible conductor
- 25 mm² conductor cross-section
- Red PVC outer sheath
- 10 metre continuous reel
- Low 0.00077 Ω/m maximum resistance at 20°C
Technical Specs
| Conductor size | 25 mm² |
| Nominal current rating | 170 A catalogue figure |
| Conductor construction | 322 × 0.30 mm strands |
| Length | 10 m (32.8 ft) |
| Colour | Red |
| Maximum outside diameter | 10.1 mm |
| Maximum resistance at 20°C | 0.00077 Ω/m |
Compatibility / Fitment Guide
This cable has no engine-model fitment list. Compatibility depends on the specified 25 mm² conductor size, circuit length, current, voltage-drop target, installation environment and terminal arrangement.
| System voltage | Low-voltage DC battery systems where 25 mm² cable is confirmed by calculation and equipment instructions. |
| Typical circuits | Battery positive feeds, charging links, starter feeds and DC distribution within the calculated current and voltage-drop limits. Red is normally used for DC positive. |
| Required sizing check | Calculate with the maximum circuit current, the full positive-and-return conductor length, permitted voltage drop, duty cycle, ambient temperature and any bundling or engine-space derating. |
| Termination | Use crimp lugs made for 25 mm² cable and the terminal stud size. Crimp with the correct calibrated hex or hydraulic tooling, support the cable mechanically and seal exposed joints with adhesive-lined heat-shrink. |
| Polarity identification | Red normally identifies DC positive. Verify the existing vessel wiring convention and protect the positive conductor according to the equipment maker and applicable standard. |
| Do not select by | Engine horsepower or the catalogue amp figure alone. Confirm the engine/battery manufacturer's cable-size table and the applicable marine electrical standard before installation. |
Important: A nominal 170 A rating does not make 25 mm² suitable for every 170 A circuit. Starter surge, long runs, continuous loads and hot or bundled installations can require a larger conductor.
Part Number Cross Reference
| AMC / manufacturer code | PVC25.10.R |
| 4Boats SKU | PVC25.10.R |
| Size / reel / colour | 25 mm² / 10 m / Red |
Use the exact SKU, conductor size, reel length and sheath colour when matching this product. Similar-looking cable from the same range may have a different cross-section or reel length.
Frequently Asked Questions
Can I choose this cable from the amp rating alone?
No. The stated figure is a nominal catalogue rating. Safe installation depends on circuit length, allowable voltage drop, duty, temperature, bundling, protection and the equipment manufacturer's instructions.
How is cable-run length measured?
For voltage-drop calculations use the complete current path: the positive feed plus the negative return, unless your chosen calculator explicitly asks for one-way length.
Are terminals included?
No. This listing is for cable on a reel. Select lugs separately to match the conductor cross-section and each terminal's stud diameter.
Can unused cable be installed as AC mains wiring?
No assumption should be made from conductor size alone. Use it only within the product's stated voltage/application rating and the applicable wiring standard.
Installation note: Isolate all power sources before work. Protect positive conductors as required by the equipment manufacturer and applicable marine standard, while observing any specific starter-circuit provisions.
For the products under £150 the shipping is £6.99.
Free delivery for most items over £150.
